Cyron Lighting Vanishing Lights - Manual (Page 5)

Tape:
Test a small area to make sure cleaning wipes do not
affect the mounting surface. Wipe the bottom of the lightbars and
mounting surfaces with the cleaning wipes. Let the surfaces dry.
Remove one side of tape liner and apply to the lights as shown in the
figure above. Place the lights in the intended area while paying close
attention to wires and proper placement. Apply pressure for 5 seconds.
If possible place lightbars far enough from each other so the
wires are not very loose or hanging down.
Bracket: DO NOT USE SCREWS FOR FASTENING TO FRAGILE
SURFACES OR ELECTRICAL DEVICES. Mount the brackets using
screws provided. You may also choose the two sided tape or other
types of hardware that better suit the mounting surface. Make sure the
brackets are lineup up properly.