Cyron Lighting HTW1000 RGB - Manual (Page 6)

Turn-off timer. There are 5 timers of 1, 2, 3, 4 and 5 hours.
Each time the button is pressed the lights will flash according
to the number of hours.
>First press; lights flash once; system turns off in 1 hour.
>Second press; lights flash twice; system turns off in 2 hours.
>Third press; lights flash three times; system turns off in 3
hours. Same method applies for up to 5 hours.
Red, Green and Blue COLOR DIALS allow adjustment of
each color from zero brightness to full brightness in 50 steps.
The UP arrows increase and down arrows decrease the
brightness level of each particular color. By combining
different levels of each color there are more than 117,000
color combinations possible. Use COLOR DIALS to match
décor colors, create varies tones of white light, reduce the
brightness of colors or memorize custom colors of your own
in the MEMORY buttons.
COLOR DIALS only operate on memorized colors
and PAUSED colors.
You cannot press-and-hold to rapidly change thru the
50 steps. Buttons must be pressed once for each step.
SOUND MODE. The lights will interact with sound. Keep in
mind the microphone is placed inside the controller and
therefore picking up the ambient sound of where the controller
unit is placed. Alternatively, you may plug the line out of your
audio system in to the MIC input of HTW1000 controller. A
generic cord has been provided. Depending on your audio
system you may need a different type cable.
a
DO NOT connect audio input of controller to speaker
outputs. Controller will be damaged.
Cool-White light preset.
Other tones of white can be achieved by COLOR
DIALS. In general, lowering the green and blue will
generate “warmer” tones of white.
Memory buttons 1 thru 7 can be used to memorize colors to be
recalled at any time. To memorize a color press the
button and then press the desired memory button 1 thru 7.