Airlink101 300N Draft 802.11n Wireless Router AR680W - Manual (Page 8)

Connecting the Router Wirelessly
Below are the default wireless settings of the router. You must configure your wireless network
card to the same settings in order to establish a wireless connection to the router. Please refer
to your wireless network card’s manual on how to configure these settings.
SSID: default
Operating Mode: Infrastructure
Authentication: Open System
Channel #: 6
WEP: disabled
If you want to change the router’s wireless settings, log in to the router and select the
Wireless tab. Be sure to click Apply and OK to save the settings.
For information on changing the router’s log in password and enabling wireless encryption,
please refer to the User’s Manual in the provided CD.
Step 3 Click Apply and OK to save the setting.
Go to the Status tab, Internet connection section to verify that you are getting valid IP
address information. If you have trouble connecting to the Internet, please go through the
Troubleshooting section at the end of this installation guide.
Section 4