American Fibertek MXR2-SM-FX-ST - Manual (Page 4)

4
D
C
I
N
5
V
F
X
L
IN
K
L
IN
K
/A
C
T
2
L
IN
K
/A
C
T
1
S
P
D
2
S
P
D
1
R
X
T
X F
IB
E
R
P
W
R
2
1
Media Converter MX2-MM-FX-SC
10/100BASE-TX To 100BASE-FX
american f ibert ek
MX2 Series
MX2 SERIES POWER SOURCE
THIS PRODUCT SHALL BE POWERED BY A LISTED CLASS 2 POWER SUPPLY ONLY.
MX2 series units require a +5VDC power source for proper operation. The DC input is diode protected.
In the USA and in Canada a 5 Volt DC power supply is supplied with this unit. The negative side of the
power input is directly connected to ground. ANSI/NFPA 70 Class 2 wiring is recommended.
MX2 SERIES POWER CONNECTION
Power is supplied to the MX2 series units via a connection on the right side of the unit (refer to the
drawing above).
MX2 SERIES FIBER DATA CONNECTIONS
The fiber optic connections are made via ST connectors located on the left side of the unit. The TX port
of this unit is connected to the RX port of the corresponding unit.
MX2 SERIES COPPER DATA CONNECTIONS
The UTP Ethernet input/output connections are made via RJ45 plugs on the left side of the unit. A
maximum CAT5 wire length of 100 meters is permitted.