American Fibertek RR-91600D-SL - Manual (Page 5)

5
FIBER CONNECTIONS
The RT-91600D-SL consists of two independent RT-980D series eight channel units that
transmit at different wavelengths. Each eight channel transmitter has an SC fiber
connector on the back of the unit. A short patchcord (supplied) connects this fiber port to
the correspondingly labeled fiber port on the RT-CWDM-4 fiber multiplexer. The fiber
optic connection to the site infrastructure is made via a SC connector located on the
bottom of the RT-CWDM-4. Be sure to allow sufficient room for the required minimum
bend radius of the fiber cable used.
Connections to the RR-91600D-SL mirror that of the RT-91600D-SL. See the drawing
below for both the RT-91600D-SL and the RR-91600D-SL connections.
Rear View RT-91600D-SL or RR-91600D-SL
VIDEO INPUT / OUTPUT CONNECTIONS
Video input and output connections are located on the rear of the unit. A BNC connector
is provided for each channel. The video inputs are connected to an appropriate 75
Ω
baseband video source such as a camera or a video recorder output. The 75
Ω video
outputs can be looped through typical baseband video inputs of switchers, recorders and
other equipment as required. For proper operation, the outputs must be terminated with
75
Ω. For optimum performance the video cables should be the shortest length of coax
practical.