American Fibertek RR-91600D-SL - Manual (Page 4)

4
INSTALLATION
THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND
SHOULD CONFORM TO THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 AND
LOCAL CODES.
The individual rack cards slide into any of the open slots in the SR-20D subrack. The
recommended configurations are shown below. Use a small screwdriver to push and
lock the ¼ turn fasteners into place.
POWER SOURCE
Power to the unit is supplied by the subrack. Please refer to the SR-20 and PSR-2
instructions for further details.
POWER CONNECTION
Power is supplied to the individual units via a four finger backplane connector. The
individual components can be inserted into the subrack or removed from the subrack
with power applied to the backplane.