American Fibertek MRX-8885C - Manual (Page 8)

8
MTX-8885C STATUS INDICATORS
The MTX-8885C transmitter provides the following front panel LED status indicators to aid in
installation and troubleshooting:
DATA
These indicators turn green when any data activity is present. An active DATA TX LED indicates
data is present at the input terminals to the MTX-8885C. An active DATA RX LED indicates data
is present at the output terminals of the MTX-8885C. When configured for RS-485, an active Hi-
Z LED indicates the MTX-8885C has seized the data line to allow data flow. The intensity of the
indicators will vary with input data patterns, however, the Hi-Z LED will typically appear dimmer
than the data Tx and Rx LEDs. The data channels associated with these front panel DATA
LEDs are listed below.
Configuration Protocol
DATA 1 TX DATA 1 RX DATA 2 TX DATA 2 RX
RS485 Configuration RS485 Tx RS485 Rx Hi-Z Hi-Z
RS422 Configuration RS422 Tx RS422 Rx Not Used Not Used
RS232 Configuration Not Used Not Used RS232 Tx RS232 Rx
RS422/RS232 Configuration RS422 Tx RS422 Rx RS232 Tx RS232 Rx
OLI
A bi-color LED indicator monitors the optical input power of the data signal that is being
received at the MTX-8885C from the MRX-8885C. AC power and optical input status associated
with this LED are summarized below.
Optical Level Indicator AC Power Status Optical Status
Green On Proper Optical Input Power Present
Red On Optical Input Not Detected
Off Off Check Power Supply Input
VIDEO
A bi-color LED indicator is provided for each of the eight video channel inputs. AC power and
video status associated with each of these LEDs are summarized below.
Video Presence LED AC Power Status Video Status
Green On Proper Input Video Present
Red On Input Video Not Detected
Off Off Check Power Supply Input