Brewer Element Treatment 2010 User Manual

Page 4

Text mode
Original mode

Document 101289 RevA

MODEL 2010 STEP 2

STEP B: Set upholstery top and bottom on frame, with Rounded Corners of the upholstery bottom placed at
the Foot End of the table.

STEP C: Install 2 Screws A (1/4”-20 x 3”) through frame and into upholstery.

STEP D: Install 4 Screws F (1/4”-20 x 1”) through frame and into upholstery.

STEP E: Tighten Screws and insert Snap Rivets as shown.

STEP F: Slide the Dowel Rod through the paper roll and hang the Dowel Rod on the J-Bolts. Ensure a secure
fit before using the paper roll dispenser.

Snap Rivet

Foot End

Screw A

Snap Rivet

Dowel Rod

Figure A

Rounded Corner

STEP A: Install J-Bolts as shown in Figure A.

Screw F

Thread Nut L (3/8”) completely onto J-Bolt.
Place Washer M onto J-Bolt and thread
into Backrest as shown in Figure A.
Position J-Bolt toward head of table as
shown and tighten nut against backrest.

J-Bolt R

Nut L

Washer M