Brewer Element Treatment 2010 - Manual (Page 2)

Document 101289 RevA Printed in USA © 2010 2
MODEL 2010
For the above models you will receive
two separate cartons: a frame carton,
and an upholstery carton. Inspect both
carefully for shipping incurred damage.
9/16” Open End Wrench
Phillips Screw Driver
COMPONENT IDENTIFICATION
Perform the following sequence in order when setting up
the table:
- Unpacking
- Assembly
- Leveling the Table
- Installing the Paper Roll
NOTE: Inspect all boxes and contents for damage.
Report any damage to the carrier immediately.
OVERVIEW
COMPONIF MODELS 2010 HARDWARE
NOTE: Save all packaging in case re-shipment is re-
quired.
MODELS 2010 TOOLS NEEDED
CAUTION
To avoid damaging the table’s upholstery or
painted surfaces, DO NOT use a knife or any other
sharp object to open the packaging.
WARNING
Two or more people should assist in moving the table.
Use proper lifting techniques when lifting. Failure to
do so could result in serious injury!
1/4”-20 x 3” Screw A (Qty. 2)
Allen Wrench (Qty. 1)
Snap Rivet (Qty. 2)
1/4”-20 x 1” Screw F (Qty. 4)
Washer M (Qty. 2)
J-Bolt R (Qty. 2)
3/8” Nut L (Qty. 2)
1/4”-20 x 1 1/4” Screw C (Qty. 8)