GE 52048 GE 24 Hour Plug-In Heavy Duty Timer with Cover - Manual

52048
Heavy-Duty
Appliance Timer
Ratings
- 125VAC 60Hz 1875W Max
General Purpose
- 125VAC 60Hz 15A Max
Resistive
- 125VAC 60Hz 1250W Max
Tungsten
- 125VAC 60Hz TV-4,
1/3Hp Max
Complete instructions inside flap
INSTRUCTIONS:
When the timer is plugged in, the timer’s dial will turn clockwise. The pointer on
the face of the dial points to the current time of day.
1. Locate the segments around on the outer edge of the timer’s dial. These
segments, each representing 30 minutes, can be pushed down and away from
the edge of the dial (try using the tip of a pen or pencil). Conversely, segments
that have been pushed down can be easily pushed back up by hand. Be sure all
segments are pushed up before programming. Select a time period (or periods)
you want the appliance turned on, then push down ALL the segments that fall on
or within that time period. For example, to have the timer turn an appliance on at
10PM and off at 2AM, push down the segments representing 10PM and 2AM,
and ALL the segments in between. See Figure 1. You may need to turn the dial
clockwise to access the desired segments.
2. Rotate the timer’s dial clockwise until the pointer on the face of the dial points
to the current time of day. Note: Nighttime hours
(from 6PM to 5AM) are highlighted with a blue background.
3. Set master switch to the TIMER ON position.