GE ZIK30GNDII - Manual

For answers to your Monogram, ® Cafe ™ Series,
Profile ™ Series or GE ® appliance questions, visit
our website at geappliances.com or call GE
Answer Center ® service, 800.626.2000.
110120 Specification Created 2/13
Listed by
Underwriters
Laboratories
ZIC30GNDII/ZIK30GNDII
GE Monogram ® 30" Fully Integrated Customizable Refrigerators for
Dual Installation
Dimensions and Installation Information (in inches)
The Installation Space
The finished cutout width must be 30". The cutout depth must be 25" for flush installations.
• The front face of the refrigerator fits flush with 25" depth
adjacent cabinets.
Electrical
A 115V, 60Hz., 15 or 20 amp power supply is required. An
individual properly grounded branch circuit or circuit breaker
is recommended. Install a properly grounded 3-prong
electrical receptacle recessed into the back wall. Electrical
must be located on rear wall as shown.
Note: GFI (ground fault interrupter) is not recommended.
Height options
80” or * 84“
25” min. depth
30” Finished Width
Height adjustable
from 79-3/8” to 80-3/8” *
3/4”
23-3/4”
29-3/4”
1/8”
1-1/4”
4”
4”
3-1/8”
60" Finished Width
Wall
View
84"
max
80"
min
Finished
Opening
25"min. Cutout
Depth
77"
6"
Anti-tip location do not obstruct
Water Tube & Electrical Outlet
Water Line
• A cold water supply is required for automatic icemaker
operation. The water pressure must be between 40 and 120
p.s.i.
• Route 1/4" OD copper or GE SmartConnect ™ plastic
tubing between the house cold water line and the water
connection location.
• Tubing should be long enough to extend to the front of the
refrigerator. Allow enough tubing to accommodate a bend
leading into the water line connection.
• Water line can enter an opening through the floor or back wall.
• Install a shut-off valve between the icemaker water valve
and cold water cupply in the home.
Note: When two units are placed side by side,
order heater kit ZUG30.