GE ZSC1202NSS - Manual (Page 3)

24
Advance planning for 30" wall ovens with Advantium ® 120
Speedcook technology with optional storage drawer
ZSC1201NSS Advantium 120 oven with accessory
storage drawer ZX2201NSS installed above a
Monogram
® single wall oven
When installed over a single oven or a warming drawer, allow at
least 2" between the two openings. This separation will provide
clearance for bottom overlap of the Advantium oven and top
overlap of the single oven or warming drawer.
• The Advantium oven and single oven combination must use
separate electrical junction boxes.
ZSC1201NSS Advantium 120 oven with accessory storage
drawer ZX2201NSS installed above a Monogram single wall
oven and a warming drawer
• The Advantium oven and single oven combination must use
separate electrical junction boxes.
• The warming drawer must be supplied with a separate 120V,
60Hz, properly grounded receptacle.
ZSC1201NSS Advantium 120 oven with accessory storage
drawer ZX2201NSS
Order a 30"-wide single oven cabinet or cut the opening in a wall
to the dimensions shown.
ZSC1201NSS Advantium 120 oven with accessory storage
drawer ZX2201NSS installed above a Monogram warming
drawer
An anti-tip block must be installed at the rear of the warming
drawer opening. See installation instructions for complete details.
• The warming drawer must be supplied with a separate 120V,
60Hz, properly grounded receptacle.
Side-by-side installation
Install two Advantium 120 ovens in separate cutouts. Allow 4-1/2"
minimum between the cutouts. Observe all cutout dimensions
and requirements.
ZX2201NSS Accessory storage drawer
The accessory storage drawer is ideal for storing extra Advantium
trays. It is only compatible with the ZSC1201NSS. Use these
cutout dimensions for ZSC2201NSS and ZX2201NSS combination
installations. The drawer is assembled to the Advantium oven
before it is installed into the cutout.
36-3/4”
Min.
45-1/4”
Recommended
30" 23-1/2"
21"
45-1/4"
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners all
Four Sides
2" Min.
Per Oven
Requirement
2" Min.
Per warming drawer requirement
25-1/4"
22-1/4"
29-3/4"
21-1/2"
Recessed
Depth
30" 23-1/2"
25-1/4"
Min.
21"
36-3/4"
Min.
Construct
Base
Min. 3/8"
Plywood
Supported
by 2x4 or 2x2
Runners all
Four Sides
36-3/4" Min.
30"
23-1/2" Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners all
Four Sides
2" Min
Per Warming
Drawer
Requirement
25-1/4"
21"
* The middle rail
separating the
two openings
may need to be
larger than the
2" min. shown.
* Note: Additional
clearance between
cutouts may be
required. Check to be
sure the oven supports
above the warming
drawer location do not
obstruct the required
interior 23-1/2" depth
and 9-1/4" height. See
each specific product’s
installation instructions
for details.
4-1/2"
Min.
Installation note:
The ZX1201NSS and accessory storage drawer combination
cannot be installed together below a countertop.