GE PW9000SFSS - Manual (Page 14)

14
6WHS³,QVWDOO$QWL7LS%UDFH
WARNING: ANTI-TIP PRECAUTIONS:
The anti-tip brace must be installed to prevent the drawer
from tipping forward when opened and loaded.
Failure to do so could result in personal injury.
Install 2x4 or 2x2 anti-tip
brace against rear cabinet
wall 9" from floor to
bottom of brace
2x4 or 2x2 runners
or solid bottom
9"
Provide Cabinet Support
IMPORTANT: When installed below a single or double oven,
check to be sure that any oven supports above the cutout do
not obstruct the 23 1 ø 2
” required depth of the warming drawer
cutout.
„ A 2" minimum clearance between oven and warming
drawer cutouts are required. Additional clearance may be
required if 2 x 4 blocks are used to support runners or solid
floor of the oven above.
„ The warming drawer may be supported by either a solid
bottom, 2 x 4 or 2 x 2 runners.
„ The support must be level and rigidly mounted, flush with
the bottom edge of the cutout.
„ There is no way to level the drawer once it has been
installed. Be sure supports are level.
„ The entire weight of the drawer is supported by the
runners or solid floor and must be capable of supporting
150 lbs.
23 1 ø 2
”
22"
27"
2" x 4" or equivalent runners
23 1 ø 2
”
25"
30"
2" x 4" or equivalent
runners
Installation of the warming drawer.
Read these instructions completely and carefully.