GE JSP39SNSS User Manual

Jsp39sn

Dimensions and Installation Information (in inches)

JSP39SN

30" Slide-In Electric Range with Self-Cleaning Oven

Listed by

Underwriters

Laboratories

Specification Revised 4/13

320643

KW Rating

240V

11.9

208V

8.9

Acceptable

Electrical

Outlet Area

30" Min.

Shave Raised Edge To Clear

31-1/8" Wide Control Panel

Excluding Model JSS28

2-7/8"

To Front

Surface Of

Countertop

20-5/8" Door

Clearance

From Front

Surface of

Countertop

31-1/4

25-3/4**

Recommended

6" Min.

From Walls

23-3/16

15" Min.

13" Max.

2-1/2

9/16

7-1/2

2-1/2

Accessory

Backguard

36-1/4

*JXS32 is 4"

(excluding handle)

**Total depth from wall to

front of closed oven door

including handle is 27-13/16.

35-7/8"–38"

from floor to

countertop

If the countertop area is not flat, excess tension may be applied to the glass cooktop, causing breakage
and voiding the warranty. Make sure the wall covering, countertop, flooring and cabinets around the range
can withstand the heat (up to 200°F) generated by the range.

A. Allow 30" minimum clearance between surface units and bottom of unprotected wood or metal cabinet,

or allow a 24" minimum when bottom of wood or metal cabinet is protected by no less than 1/4"-thick
flame-retardant millboard covered with no less than No. 28 MSG sheet metal (.015" thick), .015"-thick
stainless steel, .025" aluminum or .020" copper.

B. This appliance has been approved for 0" spacing to adjacent surfaces above the cooktop.

However, a minimum 6" spacing to surfaces less than 15" above the cooktop and adjacent cabinetry
is recommended to reduce exposure to steam, grease splatter and heat. Allow 1/4" minimum
clearance at the back wall.

To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage space above
the cooktop should be avoided. If cabinet storage space is to be provided above the cooktop, the risk can
be reduced by installing a range hood that projects at least 5" beyond the front of the cabinets. Cabinets
installed above the cooktop must be no deeper than 13".

Note: Cabinets installed adjacent to slide-in ranges must have an adhesion spec

of at least 194° temperature rating.
Note: To reduce the possibility of scorching the side walls above the countertop

when no load is present on burners, it is recommended that a minimum 6"

spacing from adjacent side wall be allowed for possible extended high-heat

element operation.

Receptacle Locations: For all 30" Slide-In Ranges locally approved flexible service cord or conduit

must be used because terminals are not accessible after range installation. See shaded area

in drawing for location of electrical outlet box. Recommended outlet locations allow range to be

installed directly against rear wall.

Optional Kits For Slide-In

Electric Ranges

(Available At Additional Cost)
Accessory Backguards

(Attaches to the back of range

as a backguard when unit is

installed in 30" free-standing

cutout)

JXS32SS (Stainless) - 4" High

JXS32BB (Black) - 4" High

Body Sides

(Slide-in ranges are sold

without sides installed. Can

be installed on either left

or right when unit has one

exposed side [no cabinet

adjacent]. Kit contains

1 body side)

JXS77BB (Black)
Rear Filler Strip

WB07T10680 - Black Filler Strip Assembly

Optional Lower Trim Kits

(If counter height is greater

than 36.5", a lower trim kit

is recommended to extend

the useful height to 38"

maximum)

JXS56BB – Black

Dimension and installation information are shown in inches.

If you are NOT using the

optional Filler or Backguard:

23-3/16

If you are using the optional

Filler or Backguard:

If you are NOT using the

optional Filler or Backguard:

23-3/16

If you are using the optional

Filler or Backguard:

Acceptable

Electrical

Outlet Area

30" Min.

Shave Raised Edge To Clear

31-1/8" Wide Control Panel

Excluding Model JSS28

2-7/8"

To Front

Surface Of

Countertop

20-5/8" Door

Clearance

From Front

Surface of

Countertop

31-1/4

25-3/4**

Recommended

6" Min.

From Walls

23-3/16

15" Min.

13" Max.

2-1/2

9/16

7-1/2

2-1/2

Accessory

Backguard

36-1/4

*JXS32 is 4"

(excluding handle)

**Total depth from wall to

front of closed oven door

including handle is 27-13/16.

35-7/8"–38"

from floor to

countertop

A. Allow 30" minimum clearance between surface units and bottom of unprotected wood or metal cabinet,

B. This appliance has been approved for 0" spacing to adjacent surfaces above the cooktop.

For answers to your Monogram

or GE

appliance questions, visit our website at

geappliances.com or call GE Answer Center

service, 800.626.2000.

All GE ranges are equipped with

an Anti-Tip device. The installation

of this device is an important,

required step in the installation

of the range.