beautypg.com

GE AEM25DP User Manual

Page 5

background image

5

GEAppliances.com

Cool Mode

Use the Cool mode at Low, Med, High or Auto Fan

Speed

for cooling . Use the Temperature Increase

/ Decrease

▼ pads to set the desired temperature

between 64°F and 86°F in 1°F increments .
An electronic thermostat is used to maintain the room

temperature . The compressor will cycle on

and off to keep the room at the set level of comfort .

Set the thermostat at a lower number and the indoor

air will become cooler . Set the thermostat at a higher

number and the indoor air will become warmer .
NOTE: If the air conditioner is off and is then turned on

while set to a

Cool setting or if turned from a fan

setting to a

Cool setting, it may take approximately

3 minutes for the compressor to start and cooling to

begin.

Cooling Descriptions

For Normal Cooling

—Select the Cool mode and

High

or Med fan with a middle set temperature .

For Maximum Cooling

—Select the Cool mode

and High fan with a lower set temperature .
For Quieter and Nighttime Cooling

—Select the

Cool

mode and Low fan with a middle set

temperature .

Fan Only Mode

Use the Fan Only Mode at Low, Med or High fan

speed to provide air circulation and filtering without

cooling . Since fan-only settings do not provide

cooling, a Set temperature cannot be entered . The

room temperature will appear in the display .

NOTE: Auto Fan Speed cannot be used when in the

Fan Only Mode.

Energy Saver Mode

Controls the fan .
ON

—The fan will cycle on and off with the

compressor . This results in wider variations of room

temperature and humidity . Normally used when the

room is unoccupied . NOTE: The fan may continue to
run for a short time after the compressor cycles off.

OFF

—The fan runs all the time, while the compressor

cycles on and off .

In the case of a power outage or interruption, the

unit will automatically restart in the settings last

used after the power is restored . If the Delay 1–24hr

feature was set, it will resume countdown . You may

need to set a new time if desired .

Power Outage Recovery Feature

Set to Auto fan speed for the fan speed to

automatically set to the speed needed to provide

optimum comfort settings with the set temperature .
If the room needs more cooling, the fan speed

will automatically increase . If the room needs less

cooling, the fan speed will automatically decrease .
NOTE: Auto Fan Speed cannot be used when in the

Fan Only Mode.

Auto Fan Speed

Do Not Operate in Freezing Outdoor Conditions

This cool-only air conditioner was not designed for

freezing outdoor conditions . It must not be used in

freezing outdoor conditions .

n

To ensure proper operation, aim the remote

control at the signal receiver on the air

conditioner .

n

Make sure nothing is between the air conditioner

and the remote control that could block the

signal .

n

The remote control signal has a range of

up to 20 feet .

n

Make sure batteries are fresh and installed

correctly as indicated on the remote control .

n

Remote contains a magnet allowing it to attach

to metal surfaces .

Remote Control