beautypg.com

Warning, Installation instructions, Dryer exhaust to left or bottom cabinet – GE GTDS850GDWS User Manual

Page 9: Bathroom or bedroom installation, Mobile or manufactured home installation, Tab location adding new duct, Garage installation

background image

Installation Instructions

9

13

DRYER EXHAUST TO LEFT OR BOTTOM

CABINET

Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45º using a flat
blade screwdriver.

10

BATHROOM OR BEDROOM INSTALLATION

?The dryer MUST be vented to the outdoors. See EXHAUST

INFORMATION section 6.

?The installation must conform with local codes or, in the

absence of local codes, with the NATIONAL FUEL GAS CODE,
ANSI Z223

MOBILE OR MANUFACTURED HOME
INSTALLATION

?Installation must conform to the MANUFACTURED HOME

CONSTRUCTION & SAFETY STANDARD, TITLE 24, PART
32-80 or, when such standard is not applicable, with
AMERICAN NATIONAL STANDARD FOR MOBILE HOME,
ANSI/NFPA NO. 501B.

?The dryer MUST be vented to the outdoors with the

termination securely fastened to the mobile home
structure. (See EXHAUST INFORMATION section 6).

?The vent MUST NOT be terminated beneath a mobile or

manufactured home.

?The vent duct material MUST BE METAL.
?KIT 14-D346-33 MUST be used to attach the dryer

securely to the structure.

?The vent MUST NOT be connected to any other duct,

vent, or chimney.

?Do not use sheet metal screws or other fastening devices

which extend into the interior of the exhaust vent.

?Provide an opening with a free area of at least 25 sq. in.

for introduction of outside air into the dryer room.

11

TAB LOCATION

ADDING NEW DUCT

Detach and remove the bottom or left side knockout as
desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer. Protect sharp edges
around the knockout and exhaust opening with the tape.

Cut the duct as shown and keep portion A.

14”

A

B

FIXING HOLE

12

?7>+78/389'11+*/3-'7'-+82:89(++1+;ated

BEND TAB
UP 45

o

Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previously to secure

RIGHT OR
LEFT SIDE
EXHAUST

PORTION "A"

FIXING
HOLE

the duct in place through the tab on the appliance base.

GARAGE INSTALLATION

(IF ALLOWED BY LOCAL CODES)

*

The internal elbow must be included in the total elbow count.

Disconnect dryer from electrical supply.
Wear gloves and arm guards.
Close the back opening with cover plate

(Kit WE1M454).

Failure to do so may result in electrical
shock or lacerations.

Electrical Shock

Hazard

NOTE

: the long vent model (GTDL740GDWW) is capable of rear

and bottom venting only.

WARNING

This manual is related to the following products: