GE JVM6175DFWW - Manual (Page 21)

5
ADAPTING MICROWAVE
BLOWER FOR
RECIRCULATION (cont.)
C3.
21
Place the blower unit back into the opening.
CAUTION:
Do not pull or stretch
the blower unit wiring. Make sure the wires are
not pinched.
Installation Instructions
NOTE: When mounting
the microwave oven,
thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift
oven by pulling cord.
Lift microwave, tilt it
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
2 Rotate front of oven
up against cabinet
bottom.
1
6
MOUNT THE MICROWAVE
OVEN C4.
CAUTION:
FOR EASIER
INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL
THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from overtightening
screws.
Close the blower door. Secure the blower
and blower door to the microwave oven using
the retaining screws from Steps 1 and 2.
Back of
Microwave
Oven
Blower Motor Door
Retaining Screw
Blower
Blower
Retaining Screw
Blower
Retaining
Screw