GE GWS04HAESS - Manual (Page 4)

Installing the wine center.
4
Removing the Packaging
Before using the wine center, be sure all packing materials and tape have been removed,
including the protective film covering the control and any film protecting the cabinet.
If you are discarding an old refrigeration product, remove the doors to reduce the danger
of children being trapped inside.
To raise the appliance
„ The wine center can be freestanding or can
be installed under the counter, with proper
clearances.
„ Allow the following clearances for ease
of installation, proper air circulation and
electrical connections:
Each side
1/2” (12 .7 mm)
Top 2” (51 mm)
Back 2” (51 mm)
„ Before connecting the appliance to the
power source, let it stand upright for
approximately 2 hours. This will reduce
the possibility of a malfunction in the
cooling system from handling during
transportation.
„ Do not install the wine center where the
temperature will go below 55°F (12,7°C)
or above 90°F (32,2°C). If the room
temperature is below the temperature
setting, the wine center will not operate
(for instance, if the room is at 55°F (12,7°C)
and the setting is 60°F (15,6°C), the unit
will not run).
„ Install the wine center on a level floor.
„ Do not install the wine center where it
will be subject to direct sunlight, heat or
moisture.
„ Do not store or install this appliance
outdoors.
Installation Guidelines
Adjustable legs at the front corners of the
wine center should be set so the wine center
is firmly positioned on the floor, with a 1/8” tilt
to the back to help the door closure.
To adjust the leveling legs, turn the legs
counterclockwise to raise the wine center,
clockwise to lower it.
Leveling Legs
To secure the door lock, push the key in and
rotate 90° clockwise.
To unlock, push the key in and rotate 90°
counter-clockwise.
Door Lock
Key
Lock