beautypg.com

Remaining in ready mode, Remote-starting, Vehicle presets – Autostart AS-1785 SH User Manual

Page 3: Driving off

background image

User Guide

AS-1785 SH

P. 3

2. With the engine already running, apply the parking brake and release the brake pedal.

Make sure to release the brake pedal.

3. Within 20 sec. press

LOCK

,

UNLOCK

or

START

on the transmitter.

The parking lights will flash 3 times quickly and remain lit.

4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:

a.

LOCK

to lock the doors and shut down the engine;

b.

UNLOCK

to unlock the doors and shut down the engine;

c.

STOP

to shut down the engine without affecting the doors.

Remaining In Ready Mode

Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However, should
any of the following occur, the vehicle will exit Ready Mode – thus eliminating the remote start
option until Ready Mode is restored:

• Door opened;

• Hood opened;

• Brake pedal pressed;

• Parking brake disengaged;

• Ignition key turned to the

IGNITION ON (RUN)

position.

Should any of the above occur, Ready Mode will be cancelled.

Note: The unit will notify the user that it has exited Ready Mode by giving 3 slow flashes
(parking lights).

Remote-starting

Press the

START

button for approx. 1 second. The parking lights will come

ON

to inform you that the

Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will start.
The parking lights will remain

ON

during the pre-programmed run time of the engine.

If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on

HIGH

. It is recommended to leave the settings on

LOW

or

MEDIUM

instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are

OFF

. Leaving the headlight switch

ON

on certain types

of vehicles could cause them to remain

ON

even after remote starter shut down, resulting in a dead

battery.
Driving Off

With the vehicle running under remote control, press the

UNLOCK

button to disarm and unlock the

doors. Enter the vehicle and do the following:

Turn the ignition key to the

IGNITION ON (RUN)

position. (Do not turn the key to the

CRANK

position while the engine is running. This would cause the starter motor to re-engage.)

Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.