GE GFWR4800FWW - Manual (Page 2)

This quick reference guide is provided for informational purposes only and does not replace, modify or change in any manner the
Owner’s Manual & Installation Instructions.
consumer quick reference guide
View videos on use and care at www.geappliances.com/videos-media/
care & cleaning To ensure that your washer operates as designed,
please follow the care and cleaning steps detailed below
cleaning the pump filter
cleaning the
door gasket
STEP 1: Open the
access door using a
coin or flat screwdriver
in the notch of the
door and pull down
the pour spout.
STEP 2: Place a shallow
pan or dish under the
pump access door and
towels on the floor for
protection. It is normal
for up to a cup of water
to drain from the filter.
STEP 3: Turn pump filter
counterclockwise and
remove the filter slowly
to let the water drain.
STEP 4: Clean the
debris from the filter.
STEP 5: Replace the
filter by pushing in
firmly and turning
clockwise until tight-
ened securely. Flip up
the pour spout and
close the access door.
To clean the interior of the washer,
use the BasketClean feature located
on the control panel using the
following procedure:
STEP 1: Remove any garments or
objects from the washer to ensure
the basket is empty.
STEP 2: Open the washer door
and add tub cleaner or lime scale
remover directly into the washer
basket.
STEP 3: Close the door and select
the BasketClean cycle. Push the
START button.
STEP 4: When the BasketClean
cycle is working, you will see CLn
on the display. The cycle will
complete in about 90 minutes.
Do not interrupt the cycle.
STEP 5: After the cycle is complete,
leave the door open slightly for
ventilation.
BasketClean may be interrupted
by pressing the START/PAUSE
button in between cycles. when
interrupted, be sure to run a
complete BasketClean cycle
before using the washer.
For more information on the Basket-
Clean feature, refer to your Owner’s
Manual & Installation Instructions.
STEP 1: Open the
washer door.
STEP 2: Press down
on the door gasket
and pull down on the
interior gasket with
your fingers.
STEP 3: Remove any foreign objects
trapped inside the interior gasket.
STEP 4: When finished cleaning,
remove your hands and the gasket
will return to operating condition.
NOTE: Make sure nothing is blocking
the holes behind the gasket.
NOTE: Clean pump filter
every 6 months or sooner if
unit is not draining properly.
Video
Scan this code
to watch a video
on this topic.
Instructions en Français - Voir le Manuel du propriétaire • Instrucciones en Español - Ver el Manual de instrucciones
cleaning the interior of the washer
getting started
great features of this washer
Uses the ideal pre-
programmed wash &
rinse settings to tackle five
common tough stains.
For select cycles, the washer
will add steam early in
the cycle to assist with
loosening stains.
Use to obtain on Extra Rinse
after the primary rinse. On
some models, a third rinse
(Max) can be selected.
On certain cycles, you can
save energy by selecting
the eWash option to adjust
water temperature and spin
times.
For heavily soiled items,
select this extra wash
before the main wash using
prewash detergent in the
dispenser.
For soaking items before
washing. After a brief
tumble, items can soak for
30 minutes to 8 hours per
your selection.
For select cycles, the washer
will tumble dry a small
load for up to 8 hours after
washing so clothes will be
ready to wear.
truths and myths
F or a list of truths and myths about frontload washers, please consult your Owner's Manual under the
section titled Before you call for service...
service
Before you call for service, review the detailed troubleshooting tips in the Owner’s Manual. If needed, schedule a visit from GE’s
local factory service team for advanced, outstanding service by visiting localgeappliancerepair.com or calling 866.530.7025.
DO NOT DISCARD. RETAIN FOR FUTURE USE.
STOP
routine maintenance
Genuine GE Parts and Accessories make appliance maintenance easy by providing cleaning products, replacement parts
and accessories that are designed to keep your appliance at peak performance. To order direct visit geapplianceparts.com
or call 800.626.2002.
ImPORTANT
• Run BasketClean with tub cleaner once a month.
• After the completion of a BasketClean cycle, the interior of your washer
may have a bleach smell
• It is recommended to run a light-color load after the BasketClean cycle
© 2013 General Electric Company PC73246 Pub. No. 31-16698-1
➊ Load clothes into your washer
and close the door.
➋ Press Power to turn on the
washer.
➌ Turn the Knob to the desired
cycle or use my Cycle to
program or recall your
favorite cycle.
➍ Open the dispenser and add
detergent, bleach and fabric
softener, as desired. This washer
multi-doses the detergent in small
amounts during wash to achieve
the best cleaning.
➎ Press start to begin the wash
cycle. The machine will weigh your
clothes and add the proper amount
of water. When the wash cycle is
finished, the door will unlock.
Use only
detergent
on some models
or
Start/Pause
on some models
Power