Asus Motherboard P5VDC-MX - Manual (Page 39)

A S U S P 5 V D C - M X A S U S P 5 V D C - M X A S U S P 5 V D C - M X A S U S P 5 V D C - M X A S U S P 5 V D C - M X 1 - 2 7 1 - 2 7 1 - 2 7 1 - 2 7 1 - 2 7
2 . 2 . 2 . 2 . 2 . P r i m a r y / S e c o n d a r y I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E , P r i m a r y / S e c o n d a r y I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E , P r i m a r y / S e c o n d a r y I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E , P r i m a r y / S e c o n d a r y I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E , P r i m a r y / S e c o n d a r y I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E ,
S E C _ I D E )
S E C _ I D E ) S E C _ I D E ) S E C _ I D E ) S E C _ I D E )
The onboard IDE connectors are for Ultra DMA 133/100/66 signal
cables. There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to the
motherboard’s IDE connector, and then select one of the following
modes to configure your device.
P5VDC-MX
®
P5VDC-MX IDE connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
PRI_IDE
SEC_IDE
PIN 1
1. Follow the hard disk drive documentation when setting the device in
master or slave mode.
2. Pin 20 on each IDE connector is removed to match the covered hole
on the UltraATA cable connector. This prevents incorrect orientation
when you connect the cables.
3. The hole near the blue connector on the UltraATA cable is
intentional.
If any device jumper is set as “Cable-Select, ” make sure all other device
jumpers have the same settng.
Drive jumper setting Mode of derve(s) Cable connector
Single device Cable-Select or Master - black
Cable-Select Master black
Slave gray
Two devices Master Master black or gray
Slave Slave