Amcor NanoMax PORTABLE AIRCONDITIONER - Manual (Page 9)

Operation
1. ON/OFF
Press the
ON
/
OFF
-button to switch the unit on or off.
2. Setting the Timer
Press the TIMER button, which will start the timer counter function.
Each press of the timer button will advance the timer setting by 1 hour, for setting
1-12 hours. If you pass the desired hour setting, you must advance the numbers
completely through 12, to start timer count from 1. When set, the
TIMER LED
will light up.
When the set hours have elapsed, the unit will turn off automatically.
The display will show the hour(s) remaining when you press the
TIMER
button.
By pressing the
TIMER
button but without turning the unit on, you can pre-set in how
many hour(s) the unit will switch on automatically.
3. Setting the Operating Mode
Select the required operating mode:
COOL
,
FAN
, or
AUTO
. The corresponding
LED
will lit.
In
AUTO
mode the unit will select cooling or fan depending on the ambient temperature.
4. Fan Speed
Select the fan speed, the corresponding
LED
will lit:
LOW
or
HIGH
.
5. Increase UP or DOWN
When the unit is ON, the display always shows the room temperature.
Press button UP or DOWN to see the current set temperature and adjust if necessary,
in the range of 62ºF to 90ºF. After 8 seconds, the room temperature will be displayed.
Warning lights COMPRESSOR and WATER FULL
When the water container is full, the unit automatically stops, the warning light WATER FULL
will fl ash to signal that the container must be emptied (see page 9, “Emptying The
Water Container”).
When the unit is cooling, the compressor light will be on. If this light is off further cooling
is not needed at this time, or the compressor may be de-icing its coils.
The fan can still be on.
7
COOL
MODE
FAN
LOW
FAN
SPEED
ON/OFF
HIGH
COMP.
WATER FULL
TIMER
UP DOWN
TIMER
5 3 2 1 4