beautypg.com

Acnodes Aficio AP4510 User Manual

Page 38

background image

Installing Options

28

2

Troubleshooting

IEEE 1394 Printer Removal Utility

If you cannot print when the printer is
connected via the 1394 Interface Unit
or error messages appear, follow the
procedure:

AAAA

Make sure the 1394 Interface Unit
is installed properly.

BBBB

Make sure the IEEE 1394 cable is
connected properly.

CCCC

Restart the computer.
If the problem still exists, go to step

D

.

DDDD

Disconnect all the IEEE 1394 ca-
bles from the computer.

EEEE

If you uninstall the printer driver
when the printer is connected to a
computer with “SCSI print”, the
printer driver may not be unin-
stalled properly. To uninstall the
driver properly, use the IEEE 1394
Printer Removal Utility on the
CD-ROM that comes with the
printer.
Stored in: CD-ROM labeled "Print-
er Drivers and Utilities"\DRIV-
ERS\UTILITY\1394\

Note

❒ For more information about the

IEEE 1394 Printer Removal Util-
ity, see the README file in the
same folder as the program.

FFFF

Restart the computer.

Invalidate Device for Windows 2000

With Windows 2000, if "Detect New
Hardware Wizard" appears every
time you restart the computer or un-
plug the cable, invalidate the device
using the following procedure.

AAAA

In "Start to Search New Hardware
Wizard", click [Next].

BBBB

Confirm that "Automatic search
for a better driver [Recommended]"
is selected in "Installation of the
Hardware Device Driver", and
then click [Next].
Uncheck all the check boxes in
"Searching Location Options" in
"Specification of Driver File", and
then click [Next].

CCCC

Clear all the check boxes in
"Searching Location Options" in
"Specification of Driver File", and
then click [Next].

DDDD

Confirm that "Invalidate Device"
in "Search for Driver File" is se-
lected, and then click [Finish].

Invalidate Device for Windows Me

With Windows Me, if "Add New
Hardware Wizard" starts every time
you restart the computer or unplug
the cable, invalidate the device using
the following procedure.

AAAA

If "Windows has found the fol-
lowing new hardware:" appears,
confirm that "Automatic search
for a better driver [Recommended]"
is selected, and then click[Next].

BBBB

When "Windows was unable to
locate the software for this de-
vice." appears, click [Finish].

Setup-F3_FM.book Page 28 Friday, October 5, 2001 8:27 PM