Abocom FE1000 - Manual (Page 2)

HARDWARE INSTALLATION
This chapter describes how to install the dual speeds
Fast Ethernet PC Card in your notebook computer
and connect it to network.
The PC Card could be connected to either 100Mbps
Fast Ethernet or 10Mbps Ethernet over unshielded
twisted pair (UTP) cable. The PC Card has the
ability automatic sensing and operating on either
speed without manual reconfiguration.
Please refer to Software Installation on how to
install network drivers using menu driven
installation utility.
Inserting the Dual Speeds Fast Ethernet PC
Card
1. Hold the PC Card with wide connector toward the
slot and the brand label facing upward.
2. Insert the PC Card and push it firmly into the
bottom.
(Please see the figure on the next page for
reference)
Removing the Dual Speed Fast Ethernet PC
Card
It’s quite different for various computer mechanical
designs. Please refer to the PC Card removal
instruction in the document for your notebook
computer.
-1-