HP Pavilion f70 17 inch Flat Panel Monitor - Manual (Page 11)

11
hp pavilion f50/f70 LCD Monitor
Setting Up the Monitor
Setting Up the Monitor
Place the monitor on a flat, sturdy surface. Ensure that the operating
site is free from excessive heat and moisture. For best performance,
make sure nothing is resting on the monitor.
WARNING: Before you connect any cables or install the HP
monitor, refer to the safety instructions at the
beginning of this manual. Refer also to the
documentation that came with the computer to
ensure this equipment is correctly installed.
Connecting two computers to the monitor
The LCD monitor has two video signal connectors on the rear panel:
one analog (VGA) and one digital (DVI-D). This allows you to
connect the monitor to two computers at the same time.
When two computers are connected, you need to use the Input
Priority setting on the onscreen display (OSD) to switch from one
video signal to the other. See “Input Priority” on page 33. The LCD
must be set to one signal or the other to operate properly.
!
DVI VGA
Video
connectors
X