HP ProLiant BL680c G5 Server-Blade - Manual (Page 12)

Component identification 12
3. Remove the access panel (on page 14 ).
4. Change positions 1, 5, and 6 of the system maintenance switch to on.
5. Install the access panel (on page 15 ).
6. Install the server blade in the enclosure and power up the server blade.
7. After the system beeps, repeat steps 1 through 3.
8. Change positions 1, 5, and 6 of system maintenance switch to off.
9. Repeat steps 5 and 6.
If both the current and backup versions of the ROM are corrupt, return the system board for a service
replacement.
To switch to the backup ROM when the System ROM is not corrupt, use RBSU ("
HP ROM-Based Setup
Utility " on page 49 ).
Local I/O cable
Item Connector Description
1 Server blade For connecting to the local I/O cable
connector on the server blade front panel
2 Video For connecting a video monitor
3 USB For connecting up to two USB devices
4 Serial For trained personnel to connect a null modem
serial cable and perform advanced diagnostic
procedures