beautypg.com

Replacing the lamp – AEG SU96040-6I User Manual

Page 12

background image

Problem

Possible cause

Solution

The lamp is defective.

Refer to "Replacing the lamp".

The compressor operates

continually.

The temperature is not set cor-

rectly.

Set a higher temperature.

The door is not closed correctly.

Refer to "Closing the door".

The door has been opened too

frequently.

Do not keep the door open longer

than necessary.

The product temperature is too

high.

Let the product temperature de-

crease to room temperature be-

fore storage.

The room temperature is too

high.

Decrease the room temperature.

Water flows on the rear

plate of the refrigerator.

During the automatic defrosting

process, frost defrosts on the

rear plate.

This is correct.

Water flows into the re-

frigerator.

The water outlet is clogged.

Clean the water outlet.

Products prevent that water

flows into the water collector.

Make sure that products do not

touch the rear plate.

Water flows on the

ground.

There is too much water in the

air deflector.

Clean the air deflector.

The temperature in the

appliance is too low.

The temperature regulator is not

set correctly.

Set a higher temperature.

The temperature in the

appliance is too high.

The temperature regulator is not

set correctly.

Set a lower temperature.

The door is not closed correctly.

Refer to "Closing the door".

The product temperature is too

high.

Let the product temperature de-

crease to room temperature be-

fore storage.

Many products are stored at the

same time.

Store less products at the same

time.

The temperature in the

refrigerator is too high.

There is no cold air circulation in

the appliance.

Make sure that there is cold air

circulation in the appliance.

The temperature in the

freezer is too high.

Products are too near to each

other.

Store products so that there is

cold air circulation.

There is too much frost.

Food is not wrapped correctly.

Wrap the food correctly.

The door is not closed correctly.

Refer to "Closing the door".

The temperature regulator is not

set correctly.

Set a higher temperature.

Replacing the lamp

1.

Disconnect the mains plug from the mains socket.

12

What to do if…