Avanti WC55SSR - Manual (Page 12)

12
PROBLEMS WITH YOUR WINE CHILLER?
You can solve many common Wine Chiller problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE
Wine Chiller does not operate. Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
Wine Chiller is not cold enough. Check the temperature control setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
Turns on and off frequently. The room temperature is hotter than normal.
A large amount of contents has been added to
the wine chiller.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The light does not work. Not plugged in.
The circuit breaker tripped or a blown fuse.
The light button is “OFF”.
Vibrations. Check to assure that the Wine Chiller is level.
The Wine Chiller seems to make too much noise. The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
Wine Chiller.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The Wine Chiller is not level.
The door will not close properly. The door is misaligned.
The Wine Chiller is not level.
The gasket is dirty.
The shelves are out of position.
Display flashes Error message “E0” Connection failure – there is a wire or component
that is not connected correctly.
Contact the Avanti Service Department –
1 – 800 – 220 – 5570
Display flashes Error message “E1” Temperature sensor failure.
Contact the Avanti Service Department –
1 - 800 – 220 - 5570
Display flashes Error message “E2” Defrost sensor (Coil Sensor) failure.
Contact the Avanti Service Department –
1 - 800 – 220 – 5570
Display flashes Error message “HH”
Display flashes Error message “LL” Temperature of inner cabinet is over 99ºF / 37ºC
Temperature of inner cabinet is under 32ºF / 0ºC