Avanti WC55SSR - Manual (Page 10)

10
NOTE:
 If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Wine Chiller will not start.
 When you use the wine chiller for the first time or restart the wine chiller after having been shut off
for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation
time. Once the wine chiller is running for a few hours everything will be back to normal.
 STORAGE
Many bottles may differ in size and dimensions. As such the actual number of bottles you may be able
to store may vary.
NOTE:
Capacity:
Bottle capacities are approximate maximums when storing traditional Bordeaux 750 ML bottles
and include bulk storage.
 INTERIOR LIGHT
 You can turn the interior light on or off by pushing the button marked
 CONTROL PANEL LOCK
 Your Wine chiller is equipped with an automatic Control panel lock function. This function will
prevent any unwanted changes to your temperature or power settings.
 The lock function will activate automatically 12 seconds after the last time a button is pushed on
the control panel.
 To unlock the control panel lock press and hold the (UP) and the (DOWN) buttons
simultaneously for 3 seconds the control panel will beep once indicating that the control panel is
active and the settings can be changed.
 DOOR LOCK
Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the User’s Guide. Insert the key into the lock
and turn it counterclockwise to lock the door. To lock the door do the reverse operation making sure
metal pin is engaged completely. Remove the key and place it in a secure place for safekeeping.
 SHELVES
The appliance is equipped with the wired shelves with
wooden front insert. You can move the shelves out and in
smoothly.
 To prevent damaging the door gasket, make sure to
have the door all the way opened when pulling the
bottom shelf out of the rail compartment.
 For easy access to the storage content, you must pull
the shelf approximately 1/2 out of the rail compartment,
however this unit was designed with a stopper on each
side of the shelf track to prevent bottles from falling.
 When removing the shelf out of the inner rail, make
sure to remove all items first. Then pull the shelf until
it is stopped by the stopper, and then lift the shelf. In
order to replace the shelf, repeat steps described
above in reverse.