Nilfisk-ALTO C 120.4 - Manual (Page 10)

11
,
6 After using your pressure washer
6.2 Winding up of electric
cable and high pressure
hose
carefully up.
Wind up the electric cable on
the appropriate hooks. Built-in
clip for good holding.
The lower hook can be turned
to release the electric cable.
6.1 Storing the washer The machine should be sto-
red in a frost-free room!
Pump, hose and accessories
should always be emptied of
water prior to storing as follows:
1. Stop the machine (turn
the start/stop switch (1) to
position"O") and detach wa-
ter hose and accessory.
2. Restart the machine and
activate the trigger. Let the
machine run until no more
water runs through the spray
gun.
3. Stop the machine, unplug
and wind up hose and cable.
4. Place spray handle, nozzles
and other accessories in the
holders of the machine.
Should the machine by mistake
be frozen, it will be necessary
to check it for damage.
NEVER START-UP A FROZEN
MACHINE.
Frost damages are not
covered by the guarantee!
To avoid accidents, the electric
cable and the high pressure
hose should always be winded
The high pressure washer
comes in two models: A) with
hook for storage of high pres-
sure hose (14) - B) with a hose
reel (13) , where the hose is
pushed into the reel and after-
wards winded up.