3) setting up virtual server in your lan – Asus WL-520GC User Manual
Page 16
WL-520GU/GC Broad Range Wireless Family Router User Manual
14
R
2. Select Yes to enable virtual
server. For example, if host
192.168.1.100 is FTP server
which is to be accessed by
Internet user, it means all
packets from Internet with
destination port as 21 are to
be directed to the host. Set
Well-known Application to
FTP. Port range to 21, Local
IP to the host IP, Local Port
to 21, Protocol to TCP.
3. Click Finish.
4. Click Save & Restart to
restart the wireless router
and activate the settings.
Authentication
The authentication methods supported by WL-520GU/GC include: Open, Shared
key, WPA-Personal, WPA2-Personal, WPA-Auto-Personal (TKIP. AES. TKIP+AES),
WPA-Enterprise, WPA2-Enterprise, WPA-Auto-Enterprise (TKIP. AES. TKIP+AES),
and Radius with 802.1x.
Open: This option disables authentication protection for wireless network.
Shared Key: This mode uses the WEP keys currently in use for authentication.
WPA-Enterprise, WPA2-Enterprise, WPA-Personal, WPA2-Personal, WPA-
Auto-Personal: WPA stands for WiFi-Protected Access. WPA provides two
security modes: WPA for enterprise network, and WPA-PSK for home and SOHO
users. For enterprise network, WPA uses the already existing RADIUS server for
authentication; for home and SOHO user, it provides Pre-Shared Key (PSK) for
user identification. The Pre-Shared Key consists of 8 to 64 characters.
Radius with 802.1x: Similar with WPA, this solution also uses RADIUS server
for authentication. The difference lays on the encryption mothods: WPA adopts
TKIP or AES encryption methods, while Radius with 802.1X does not provide
encryption.
When authentication and encryption are set, click Finish to save the settings and
restart the wireless router.
3) Setting up Virtual Server in Your LAN
Virtual Server is a Network Address Translation (NAT)
function which turns a computer within a LAN into a server
by allowing data packets of certain service, such as HTTP,
from Internet.
1. Click Virtual Server in NAT Setting folder to open the NAT configuration page.