Alpine CDA-9813 - Manual (Page 8)

6
-EN
Getting Started
Turning Power On and Off
Press SOURCE/POWER to turn on the unit.
• The unit can be turned on by pressing any other button except eject
c and TITLE / .
The volume level gradually increases to the previous level you
were listening to before the unit was turned off.
Press and hold SOURCE/POWER for at least 3
seconds to turn off the unit.
• The first time power is turned on, the volume will start from level 12.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after installing the CD changer, after changing the car battery, etc.
1
Turn off the unit power.
2
Press RESET with a ball-point pen or similar
pointed object.
Setting Time
1
Press TITLE / repeatedly until the time is
displayed.
For details, see "Displaying the Title/Text" (page 20).
2
Press and hold TITLE / for at least 3 seconds
while the time is displayed.
The time indication will blink.
3
Turn the Rotary encoder to adjust the hours.
4
When the hour has been adjusted, press the
Rotary encoder.
5
Turn the Rotary encoder to adjust the minutes
while the time indication is blinking.
The time is automatically set 5 seconds after the minute
adjustment. The time can also be manually set by
pressing the Rotary encoder.
• To synchronize the clock to a time signal, press the Rotary encoder
for at least 3 seconds after setting the “hour.” Minutes will be
indicated as 00. If you press the Rotary encoder for more than 3
seconds when the display shows over “30,” hours will advance.
SOURCE/
POWER DISP/
B.OUT
Opening and Closing the Movable Display
Press c.
The movable display will open.
To close the movable display, press c again.
The movable display will close.
• Do not apply shock to the movable display when it is open as it
may result in malfunction of the unit.
• The display may be dim during low temperatures and immediately
after turning on the power. The brightness will return to normal as
time elapses.
• The display will stop at the set tilt angle when closing.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Display Tilt Adjustment
The movable display may be adjusted to 3 different tilt angles
depending upon user preference.
Press TILT 98 to adjust the tilt angle of the movable
display.
• The display will close a half minute after the ignition key is turned
to the OFF position.
• The adjusted tilt angle of the display is stored in memory. There is
no need to re-adjust the tilt angle when the power is turned back on.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
TILT 98
Movable display
TITLE /
MUTE Rotary encoder c
RESET