Amana W10300459A - Manual (Page 15)

15
Connect Vent
Connect vent to exhaust outlet
1.
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
†®TEFLON is a registered trademark of E.I. Dupont De Nemours and Company.
level Dryer
Not Level lEVEl Not Level
noTE: The dryer must be level for the moisture sensing system
to operate correctly.
Tighten and adjust leveling legs
2.
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once legs are level, make sure all four legs are snug against
the ground before tightening them.
move dryer to final location
2.
Move dryer to final location. Avoid crushing or kinking vent.
After dryer is in place, remove corner posts and cardboard
from under the dryer.
Complete Installation Checklist
q Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q Check that you have all of your tools.
q Dispose of/recycle all packaging materials.
q Check dryer’s final location. Be sure vent is not crushed
or kinked.
q For power supply cord installation, plug into an outlet.
For direct wire installation, turn on power.
q Check that dryer is level. See “Level Dryer”.
q Remove film on console and any tape remaining on dryer.
q Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
q Read “Dryer Use” in your Use and Care Guide.
q Set the dryer on a full heat cycle (not an air cycle) for
20 minutes and start the dryer.
If the dryer will not start, check the following:
Controls are set in a running or “On” position. ■
Start button has been pushed firmly. ■
Dryer is plugged into an outlet and/or electrical supply ■
is on.
Household fuse is intact and tight, or circuit breaker has
■
not tripped.
Dryer door is closed. ■
level Dryer
1.
Check levelness of dryer from side to side. Repeat from
front to back.