Nilfisk-ALTO R 580 B - Manual (Page 19)

USER MANUAL ENGLISH
146 2601 000(1)2005-03 A FLOORTEC R 580 B 17
TROUBLESHOOTING
For further information, refer to the Service Manual,
available at any Nilfisk-Alto Service Center.
SCRAPPING
Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove the following
components:
–
Battery
– Polyester dust filter
– Main and side brooms
– Hydraulic oil
– Hydraulic oil filter
– Electronic boards
– Plastic components and hoses
TROUBLE REMEDY
After having turned the ignition
key (18, Fig. B) to “I” position, the
display does not illuminate and
the machine does not work.
Check that the battery
connector (4, Fig. V) is correctly
connected to the machine.
Check the F1 (1, Fig. Z) and F0
(2, Fig. Z) fuse integrity
The machine does not move
when pressing the accelerator
pedal.
Turn the ignition switch to “0”
position, then turn it to “I”
position being careful not to
activate the accelerator pedal
during this operation
The main broom does not work
Check that the related fuse (5,
Fig. V) is not deactivated;
otherwise reactivate it by means
of the related key
The side brooms do not work
Check that the related fuse (6 or
7, Fig. V) is not deactivated;
otherwise reactivate it by means
of the related key
The machine operates only when
stationary, otherwise the red
warning light turns on. Re-charge the battery. If the
problem persists, replace the
battery.
The machine collects little
debris/dust
Check if the dust filter (4, Fig. N)
is clogged
Check if the hopper (4, Fig. C) is
full
Check that the skirts (16, 17, 18,
19, Fig. C) are not broken or
incorrectly adjusted
Check if the brooms (10, 11, 12,
Fig. C) are at the correct height
The battery autonomy is low
Install a battery with greater
capacity: 240 Ah
The hopper does not lift
Check the fuse (F2, Fig. Z)
integrity
The hopper does not lift
Check the fuse (F3, Fig. Z)
integrity
Check that the hopper is lifted
from the ground at an height
greater than 270 mm
The hopper does not lower
Before lowering the hopper by
means of the related switch (15,
Fig. B), check that the hopper
has returned to the horizontal
position by means of the related
switch (16, Fig. B).
The filter-shaker does not work
Check that the main broom is
lifted with the lever (24, Fig. B)
Check the fuse (F4, Fig. Z)
integrity
WARNING!
The removed components must be
disposed of properly according to the Law
in force.