Alpine TDM-7581R - Manual (Page 18)

16
-EN
Remote Control Operation
Controls on Remote Control
(TDM-7583R only)
1 Mute Button
Press the button to lower the volume by 20 dB
instantly. Press the button again to cancel.
2 Power Switch
Press the switch to turn the power on/off.
3 - / J Button
Press the button to switch between the Play and
Pause modes for CD or Tape.
4 CD Changer Button
Press the button to change to the CD changer
operation.
5 Band/Programme Button
Radio mode: BAND Button
Press the button and the band will change as
shown below.
→
F1
→
F2
→
MW
→
LW
Tape mode: PROG button
Press the button during tape play to change the
tape direction to play the other side of the tape.
6 Volume Adjustment Buttons
To increase the volume level:
Press the
L
button
To decrease the volume level:
Press the
K
button
7 8 Button
Radio mode: Pressing the button will select, in
ascending order, stations programmed into the
radio's presets as shown below.
→ 1 → 2 ... 6
CD Changer mode: DISC Select (UP) Button
Press the button to select a disc in ascending
order.
Tape mode: Press the button once during tape
play to advance to the beginning of the next
selection.
8 g Button
Radio mode: SEEK (DN) Button
CD mode: Press the button to go back to the
beginning of the current track.
Tape mode: Press the button during tape play to
fast rewind the tape respectively.
9 f Button
Radio mode: SEEK (UP) Button
CD mode: Press the button to advance to the
beginning of the next track.
Tape mode: Press the button during tape play to
fast forward the tape respectively.
REMOTE CONTROL UNIT RUE-4185
MUTE
CD-CHG
SOURCE A.PROC
ENT
BAND
PROG
PWR
VOLUME
1
2
3
4
5
6
8
7
9
!
"