LG PQNFB17C0 - Manual (Page 5)

Installing ACP BACnet
ENGLISH
5
Installing ACP BACnet
Installing ACP BACnet
This chapter describes how to install the ACP BACnet to use.
In order to use the ACP BACnet, the installation should be performed by the following order.
STEP 1. Check the cautions during the ACP BACnet installation
Before installing the ACP BACnet, check the cautions.
STEP 2. Study the cable connections diagram of the entire system
Study the cable connection diagram of the site where the ACP BACnet is installed.
STEP 3. Set the indoor unit address
Set the address of the ACP BACnet not to be overlapped with the connect-
ing indoor unit.
STEP 4. Set PI485 and connect cables
Set DIP switch of PI485 correctly, and connect RS-485 communication
cable.
STEP 5. Install ACP BACnet and connect cables
Install the ACP BACnet, and set network and other settings.
STEP 6. Set ACP BACnet network address
Set the network address to be able to access the ACP BACnet through internet.
STEP 7. Set ACP BACnet functions
Set language, peak/demand, whether to use schedule, whether to use
power display, etc.
STEP 8. Set Web GUI access environment
Set the access environment in Web GUI, which is the operation program of
the ACP-BAC.
STEP 9. Input indoor unit and ventilator information
Set the access environment in Web GUI, which is the operation program of
the ACP BACnet.
STEP 10. Verify and check ACP BACnet installation
Verify and check whether the ACP BACnet is properly installed.
CAUTION
Installing the ACP BACnet
• The ACP BACnet installation work needs the professional technique. Therefore, the installa-
tion described in this chapter should be performed by the certified installation professional.
• Consult the service center or the professional installation agency certified by us about
any question or request related to the installation.
!