LG ARNH08GK3A2 - Manual (Page 10)

10 Hydro Kit
Selecting Target Temperature
❊
Note
: Increase 1°C or 2°F per one time pressing
: Decrease 1°C or 2°F per one time pressing
• We can change the temperature range of each mode on installation setting mode. Please refer
to Function Code 11 to 15.
• Room Temperature setting is available when Remote Room Air Sensor (sold separately) is
installed. Please refer to Function Code 03.
• Sanitary Water Tank temperature setting is available when Sanitary Water Tank is installed.
Owner's instruction
Mode Change
Turn on the product and select operation mode.
Operation Mode
• Heating Operation - The product yields hot water to use in under floor heating or FCU heating.
• Weather dependent Heating Operation - In this mode, heating setpoint is automatically determined
by pre-defined temperature profile.
1 Press Power Button to turn on the product.
2 Press OPER MODE Button to select each operation mode.
Heating operation Weather dependent
operation
1 Press SET TEMP Button to select each operation mode.
2 Adjust desired temperature by pressing Change Temperature buttons on each mode.
To raise the Temperature
To lower the Temperature
Room temperature Leaving Water tempera-
ture
Sanitary Water Tank
temperature