LG LZ-H100GXN0 - Manual (Page 12)

button on the remote controller.
It displays as the figure right side in
the direct expansion type ventilation
single operation. 1
Pressing button will change the
ventilation mode.
Pressing the button converts from 'heat
exchange
→ normal → automatic'.
2
Pressing button will change
operation mode.
- Pressing the button will convert from
'cooling
→ heating → automatic → fan.
3
Pressing button in ventilation
mode changes the strength of wind.
- Pressing the button can select
from 'Low
→ High → Super High'.
❈ Cooling/heating operation selection and the
desired temperature can be adjusted in direct
expansion type ventilation single operation.
❈ Refer to the basic operation - temperature
adjustment for changing desired temperature.
4
❈ The 88 segment display above is only displayed
when it is in direct expansion type ventilation single
operation and the air conditioner is stopped.
Direct expansion type ventilation single operation
Ventilation
mode
Heat
exchange
Normal
Automatic
Remote Controller
Display
Contents
Mode that supply/exhaust air via Total heat exchanger.
Appropriate for use in summer/winter when temperature
difference between indoor/outdoor air is severe.
Mode that exhaust the air without the Total heat
exchange method. Appropriate for use in spring/autumn
or in case of the high indoor pollution degree.
Automatically operates in the optimum ventilation mode
by measuring the indoor/outdoor air temperature of the
ventilation system.
❈ Searches the optimum status by operation mode or
setting temperature of ventilator as well as by
indoor/outdoor temperature of the ventilation system if
linked to Multi-V system. (Only for some models)
Operating Instructions (Accessory)
Single operation control
It performs ventilation operation with cooling or heating at the same time using the heat exchanger
inside the direct expansion type ventilation product.
12 Ventilator