LG LWS3010ST - Manual (Page 32)

32
REMOVING & REPLACING THE LIFT-OFF OVEN DOOR
DOOR CARE INSTRUCTIONS
M A I N E N A N C E
To replace the door:
Step. 1
Firmly grasp both sides of the door at the top.
Step. 2
With the door at
the same angle as
the removal
position, seat the
indentation of the
hinge arm into the
bottom edge of the
hinge slot. The
notch in the hinge
arm must be fully
seated into the
bottom of the slot.
Step. 3
Open the door fully. If the door will not open fully,
the indentation is not seated correctly in the bottom
edge of the slot.
Step. 4
Push the hinge locks up
against the front frame of the
oven cavity to the locked
position.
Step. 5
Close the oven door.
• Most oven doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks
are fully in place.
2. Do not hit the glass with pots, pans, or any other
object.
3. Scratching, hitting, jarring, or stressing the glass
may weaken its structure causing an increased risk
of breakage at a later time.
To remove the door:
Step. 1
Open the door fully.
Step. 2
Pull the hinge locks
down toward the door
frame to the unlocked
position.
Step. 3
Firmly grasp both sides of the door at the top.
Step. 4
Close door to the door removal
position, which is
approximately 5 degrees.
Step. 5
Lift door up and out until the hinge arm is clear of
the slot.
CAUTION
• DO NOT use harsh abrasive cleaners or sharp
metal scrapers to clean the oven door glass
since they can scratch the surface.
- It may result in shattering of the glass.
Hinge arm
Slot
about 20˚
Lock
Unlock
Hinge
lock
Hinge
arm
Hinge lock
Hinge arm
Indentation
Bottom
edge of
slot