beautypg.com

Using your p35 power amplifi er – Arcam Handbook A32 User Manual

Page 12

background image

12

Using your P35 power amplifi er

POWER (AND POWER INDICATOR LIGHT)

Switches the unit on and off. The light indicates the status of the
amplifier.

When you switch your amplifier on, the light glows amber for a few
seconds, during which time the speakers are disconnected. The light
changes to green when the amplifier is ready for use. A red light
means the amplifier is in standby mode.

The light may flash if a fault has occurred. You should unplug the
amplifier and leave it for a few minutes before reconnecting. If the
fault cannot be cleared, unplug your amplifier and contact your Arcam
dealer.

P35 POWER AMPLIFIER

SP1

SP2

POWER

NOTE: If both lights are out the amplifier will appear not to work,
as all speakers are switched off. If both are on, and low impedance
speakers are connected, overloads are more likely.

SP1 AND SP2

These buttons allow you to select and deselect the main (

SP1

)

and secondary (

SP2

) sets of speakers attached to your amplifier. An

indicator light shows which set of speakers are currently selected.