ADS Technologies NetDSL 800 ADSL Modem version 5.2b1 - Manual (Page 6)

Minimum System Requirements
1-2 NetDSL Software User’s Guide
1.3 Minimum System Requirements
• ADSL line
• 10BaseT Ethernet or USB interface
• CD-ROM drive
NetDSL gives you the option of configuring the modem using the Arescom
NetDSL Manager. The system requirements for each are listed below:
Using the NetDSL Manager:
• Ethernet card
• PC* with at least a 486 microprocessor (Pentium
®
recommended)
• CD-ROM drive
• At least 4 MB of space available on the hard disk drive
• Microsoft
®
Windows
®
95/98/2000 or Windows
®
NT 4.0 Operating
System
* You may configure the NetDSL from any PC attached to the Local
Area Network (LAN) with the requirements listed above.
1.4 Information You Will Need
To configure your modem, you will need to receive information from the remote
network to which you will connect, such as an Internet Service Provider (ISP) or
a company server. Consult the section below for a detailed list of information on
utilizing the Ethernet interface and the DSL interface. If you are unfamiliar with
any of the terms listed, refer to Appendix A,
“About Configuration Parameters.”
The following information should be obtained from your ISP or company server.
• VPI
• VCI
• DSL line code
You MAY need the following information from your ISP or company server
based on your network setup:
• IP Address
• Subnet Mask
• Gateway IP Address
• PPP User name & Password
• DNS Address