LG BP220 User Manual

Page 21

Connecting

onnecting

1. Select [Connection Setting] option in the

[Setup] menu then press ENTER (b).

2. Read the preparations for the network settings

and then press ENTER (b) while [Start] is

highlighted.

Network will automatically be connected to the
unit.

Advanced Setting

If you want to set the network settings manually,
use w/s to select [Advanced Setting] on the

[Network Setting] menu and press ENTER (b).

1. Use w/s/a/d to select the IP mode

between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.

If there is no DHCP server on the network and
you want to set the IP address manually, select
[Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using w/s/

a/d and numerical buttons. If you make a

mistake while entering a number, press CLEAR
to clear the highlighted part.

Note

3. Select [Next] and press ENTER (b) to apply

network settings.

Network connection status is displayed on the
screen.

4. Press ENTER (b) while [Close] is highlighted to

finish the wired network settings.