Using smartdiagnosis, Optional accessories, Warning – LG DLG3051W User Manual
Page 39: Specifications, Stacking kit installation

39
ENGLISH
SPECIFICATIONS
USING SMARTDIAGNOSIS
TM
If you experience problems with your dryer, call 1-800-243-0000 (1-888-542-2623 in Canada). Follow the call center agent’s instructions, and do
the following steps when requested:
1. Press to turn on the dryer. Do not press any other buttons.
2. When instructed to do so by the call center agent, place the mouthpiece of your phone very close to the POWER button.
3. Press and hold (Temp.Control) for three seconds, while holding the phone mouthpiece to the icon or POWER button.
4. Keep the phone in place until the tone transmission has finished. This takes about 6 seconds, and the display will count down the time.
• For best results, do not move the phone while the tones are being transmitted and do not touch the control panel with the phone.
• If the call center agent is not able to get an accurate recording of the data, you may be asked to try again.
• Pressing the POWER button during the transmission will shut off the SMARTDIAGNOSIS™.
5. Once the countdown is over and the tones have stopped, resume your conversation with the call center agent, who will then be able to assist
you using the information transmitted for analysis at the call center agent.
OPTIONAL ACCESSORIES
Stacking kit installation
this stacking kit includes:
• Two (2) side rails
• One (1) front rail
• Four (4) screws
tools needed for installation:
• Phillips screwdriver
To ensure safe and secure installation, please observe the
following instructions.
w
WarnInG
• Incorrect installation can cause serious accidents.
• The weight of the dryer and the height of installation make
this stacking procedure too risky for one person. Two or
more people are required when installing the stacking kit.
There is a risk of serious back injury or other injuries.
• Do not use the stacking kit with a gas dryer in potentially
unstable conditions such as a mobile home. Failure to follow
this warning can result in serious injury.
• Place the washer on a solid, stable, level floor capable of
supporting the weight of both appliances. Failure to follow
this warning can result in serious injury.
• Do NOT stack the washer on top of the dryer. Failure to follow
this warning can result in serious injury.
• If appliances are already installed, disconnect them from
all power, water, or gas lines and from draining or venting
connections. Failure to do so can result in electrical shock, fire,
explosion, or death.
1. Make sure the surface of the washer is clean and dry. Remove
paper backing from the tape on one of the stacking kit side
brackets.
2. Fit the side bracket to the side of the washer top as shown in
the above illustration. Firmly press the adhesive area of the
bracket to the washer surface. Secure the side bracket to the
washer with a screw on the back side of the bracket. Repeat
steps 1 and 2 to attach the other side bracket.
oPtIonal aCCEssorIEs
oPtIonal aCCEssorIEs