LG 47LD650H - Manual (Page 125)

6 206-4137
Installation and Setup Checklist
__ Unpack TV and all accessories.
__ Install batteries in remote control.
__ Install TV on VESA mount or stand.
Note: It may be advisable to make all cable
connections before installing on VESA mount or
stand, as appropriate.
Hardware Connections
__ Install any additional hardware as
appropriate to your institution, LAN, etc.
Cable Connections
__ Make all connections to rear jack panel and RF
antenna on MPI/PPV card.
__ Make all connections to signal, interactive
resources, and Aux sources, as appropriate.
Commercial Mode Setup
__ Complete Commercial Mode Setup (configure
all relevant Installer Menu items as required of
your institution and configure display features
for the end user).
Software Installation
__ Install or configure any software, as applicable,
for example, PPV, etc.
Setup Checklist / Overview
Setup Checklist
Commercial Mode Setup Overview
This document describes how to set up LD650H/LD655H/LG710H Pro:Centric™ TVs for Commercial Mode
either while in the Embedded b-LAN™ (EBL) module’s Pass-through Mode or its Free-To-Guest (FTG)
Mode.
Note: The b-LAN module is internal to the TV and allows the hotel/institution head end equipment to com-
municate with the TV for configuration and control. See Reference section, “b-LAN Setup & Overview,” for
further information. The b-LAN module also comprises the data tuner required for Pro:Centric operation
(see next page).
Pass-through Mode
This mode allows you to configure a Master TV Setup for cloning purposes as well as external VOD/PPV
control. Use the Installer Remote to configure Installer Menu items as required for TV operation and set up
TV features (Channel, Picture, Audio, etc.). See pages 13 to 14 for detailed information.
FTG Mode
This mode enables Pro:Idiom® decryption and also allows logical channel mapping of physical channels to
remove the need for dash tuning. FTG Configuration Application software is used to configure and/or edit
Channel Map and Installer Menu settings. See pages 24 to 27 for further information on FTG Mode and lo-
cal configuration using a PC with the FTG Configuration Application. Since these TV models are equipped
with the EBL Module, they can also be broadcast configured in FTG Mode by a Free-To-Guest Manage-
ment Appliance (FMA) head end device. Refer to the Free-To-Guest (FTG) Configuration Application
manual and/or the Installation & Setup manual for the FMA device.