LG LHT888 - Manual (Page 8)

8
Be careful of the following
If there is a strong electromagnetic wave product nearby, interference may
occur. Put the unit (Wireless Receiver and main unit) away from there.(Ex:
Microwave oven)
If there is no audio signal for longer than 10 minutes, the Wireless Receiver
and Wireless Transmitter will automatically switch to standby mode. In power
saving mode, both LEDs will turn red. LEDs will turn blue when there is any
audio signal back.
If you operate main unit then wireless speakers (rear speakers) sound within a
few seconds in standby mode.
LED indicator of Wireless
Transmitter
BLUE The main set is turned on, everything is connected
and transmitting.
RED The wireless transmitter is in standby mode.
OFF (No display) The DC cable is disconnected to the unit.
LED color Operation
LED indicator of Wireless
Receiver
BLUE The Wireless Receiver is receiving the signal of
the Wireless transmitter.
RED The Wireless Receiver is in standby mode.
OFF (No display) The Wireless Receiver is turned off.
LED color Operation
Setting an ID of Wireless
Transmitter
1 Connect the SOUND SIGNAL connector of
the transmitter and the rear (right, left) speaker
terminals of main unit with the SOUND
SIGNAL cable.:
-
2 Connect the DC cable to the unit
and transmitter.: -
3 Turn off the Wireless Receiver: POWER Switch
4 Press the ID. for more than 3 seconds:
The Blue LED indicator will quickly flicker ID.
5 Turn on the Wireless Receiver: POWER Switch
When the unit is manufactured, the ID is already set. If an interference
occurs or you use a new Wireless Receiver, an ID is set again.
ON Wireless Kit
HT762TZW-A0_DCANLLK_canENG 2/21/08 8:51 PM Page 8