Audiovox Dual Handset Cordless Phone - Manual (Page 9)

E - 8
INSTALLATION
LINE CORD CONNECTION :
Plug the telephone line cord into the modular jack on the back of the telephone base and
the other end into the modular jack of your telephone wall outlet.
AC POWER CONNECTION :
Use only the AC/DC adaptor provided with the telephone. First insert the DC adaptor
plug into the DC adaptor socket provided on the telephone base. Then plug the AC
adaptor into your main power outlet.
BATTERY INSTALLATION AND CHARGING :
This equipment uses Nickel Metal Hydride (NiMH) batteries. To keep the batteries at
full charge you can leave the handset in the base unit at all times for safe trickle
charging. During charge, the charge LED will be on and battery icons will be FLASHING.
PLACING THE BATTERY
Place the battery pack as shown below. Observing correct polarity.
LOW BATTERY VOLTAGE WARNING
At installation the battery voltage will be low and the handset should be placed on the
station for 10 hours continuously to fully charge the batteries.
If the voltage is extremely low then the handset will not function at all, but if there is
sufficient residual voltage then the handset will power up indicating low voltage. This
can be seen from both the battery icon flashing empty.
9038_2_ib_e.p65 10/31/03, 12:20 PM 8