AEG EN AGN2451 - Manual (Page 19)

8. Unscrew the handle. On the opposite
side remove the hole covers by driving a
3-4 mm drift or drill into them.
Install the handle. Fit the handle on to
the opposite side by turning it on half
circle.
Install the hole covers provided within
the accessory bag.
9. Put the cabinet in position.
WARNING!
Reposition, level the appliance, wait for at least four hours and then connect it to the pow-
er socket.
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to the side edge of the appliance.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
WARNING!
If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the gasket.
NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
BRRR!
HISSS!
CLICK!
BLUBB!
CRACK!
SSSRRR!
OK
180°
Noises 19