AEG EN AGN2451 - Manual (Page 15)

Problem Possible cause Solution
The appliance has no power.
There is no voltage in the mains
socket.
Connect another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".
The door has been open to long. Close the door.
Door interferes with venti-
lation grill.
The appliance is not levelled. Refer to "Levelling".
Misaligned door. The appliance is not levelled. Refer to "Levelling".
As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
The appliance is equipped with a longlife LED light.
Only service is allowed to replace the lighting device. Contact your Service Center
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
AGN2451 AGN2901
Dimension
Height 1650 mm 1850 mm
Width 660 mm 660 mm
Depth 680 mm 680 mm
Rising Time 25 h 25 h
Voltage 230 V 230 V
Frequency 50 Hz 50 Hz
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Technical data 15