ATON STORM A83C User Manual
Page 9
© 2007 • All rights reserved. 7
Storm Series LCR Theater Speakers
Pre-Wiring
The audio/speaker cable runs should be routed from the head-end location to the speaker
rough-in brackets (if used). At the speaker locations, securely fasten the speaker wire to the
speaker rough-in bracket. If not using speaker rough-in brackets, staple speaker wire runs in a
loose zigzag between the studs where the speaker is to be mounted to make it easier to fi nd the
cable after the drywall is installed. Zig-zagging the cable also allows fl exibility in the placement
of the speaker. Note: Do not run speaker wires closer than 12" from high voltage wires.
Speaker
Wire
Min
12”
High
Voltage
Wiring
Figure 3.6: Pre-Wiring In-Wall
Ceiling
Speaker
Wire
Speaker
Cutout
Figure 3.7: Pre-Wiring Ceiling