AT&T 9370 - Manual (Page 39)

Voice Help Menu
Use the Voice Help Menu to access the answering system from your
cordless handset or from a remote touch tone telephone, even if you do
not know or remember the command codes.
1 Connect with the answering system.
2 Press 5. The system announces a list of operations and the
buttons you need to press.
3 At the end of the list, the system beeps twice to indicate it is ready
to accept a command.
4 You can access the Voice Help Menu any time after the system has
given you the two-beep signal that it is ready to accept a
command.
Audible Signals
Signal: Means:
Long ring Incoming call
Single beep Valid button press
Three-part tone Page
Repeating three-part tone Handset Locator
Two short beeps Handset is out of range
Four short beeps Low battery
Four long beeps Base is busy
Long buzzing tone Error – unsuccessful action
Series of ascending tones Action has been successful
“Chirp” after ring Priority Call
ANSWERING SYSTEM OPERATION
AT CORDLESS HANDSET OR TOUCH TONE PHONE
37
9370_to make pdf_1ATT 6/12/00 2:07 PM Page 37